Mercury HP700 SCi - Page 90

MAINTENANCE
82
CHANGING ENGINE COOLANT
Contact your authorized Mercury Marine dealer.
CHANGING TRANSMISSION OIL
1. Remove the bilge plug and pull the drain hose through the
transom.
2. Using two wrenches, separate the drain plug from the hose.
6150
e
d
c
b
a
a - Bilge plug
b - Tether
c - Drain plug
d - Flange
e - Drain hose
3. Reinstall the drain and bilge plug after draining the fluid.
4. Remove the fill plug and add High Performance Gear Lube as
necessary to bring the fluid level within the cross‑hatched area
above the "ADD" mark on the dipstick (approximately 1 Liter
(1.1 U.S. quarts).
a
b
21710
c
a - Dipstick
b - Fill plug
c - "ADD" mark