MONITOR 2.00
2-2
MONITOR – VERSION 2.00
Basic Operation
The Monitor is an LCD multi-function display gauge. A variety of dis-
plays can be activated using the
button.
Pressing the
button scrolls the following displays: fuel used,
tachometer (RPM), fuel flow, power trim position, engine temp, wa-
ter pressure, battery voltage, range (if calibrated), and water depth
(if equipped with transducer).
The Monitor will power up when the ignition is turned on.
The display includes a backlight which allows you to read it at night.
The backlight brightness is adjustable using
button.
In the event of a warning alarm, the warning icon(s)
will be dis-
played.
Initial Power Up (Or After Master Reset)
Unit will display software level then flash the word “SEt” in conjunc-
tion with engine icon.
Press the button.
AUTO-DETECTION
The unit will begin it’s “Auto-detection” of engine type procedure. In
this procedure the Monitor checks with the engine control module
(ECM) to see what type of engine you have and presets the data moni-
toring screens accordingly, (e.g, If Monitor detects an inboard engine
connected to the data network it will turn off all engine/drive TRIM func-
tions as these functions are not used in an inboard engine installation).
The intention is to make initial setup easier.
(continued on next page)
To Next Page
Loading...
