SYSTEM TACH & SPEED
3-18
SYSTEM TACH & SPEEDOMETER
CAL 2 Tachometer Calibration
CAL 2 – This calibration level lets you configure the system sensor
inputs.
1. Press in the
MODE
and
TROLL
+
buttons and hold for approximately
10 seconds for calibration2 (Cal2) screen.
2. Press
MODE
to advance through the calibration selections.
EXTERNAL SENSORS
[EDIT]
[SKIP]
This section lets you enable or disable
the following external sensor inputs.
PITOT SENSOR?
[NO]
[YES]
[SAVE]
Is the boat equipped with a pitot sensor
to measure boat speed?
PADDLE SENSOR?
[NO]
[YES]
[SAVE]
Is the boat equipped with a paddle
wheel to measure boat speed?
TRIM SENSOR?
[NO]
[YES]
[SAVE]
Is the boat equipped with a trim sensor?
SEA TEMP?
[NO]
[YES]
[SAVE]
Is the boat equipped with a water
temperature sensor?
INVERT STEERING
[NO] [SAVE]
[YES]
Is steering angle showing up on the link
gauge opposite the direction that it should
be? If it is then this feature will reverse the
signal so it is displayed properly.
(continued on next page)
To Next Page
Loading...
Need help?
General
