18
300Mbps Whole Home Mesh Wi-Fi System
Halo S3
4.4.3 Wireless Advanced
You can congure advanced wireless settings on this page.
Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep the provided default
values, otherwise may result in lower wireless network performance.
• Transmit Power - Here you can specify the transmit power of the router. You can
select High, Middle or Low which you would like. High is the default setting and is
recommended.
• Beacon Interval - The beacons are the packets sent by the router to synchronize
a wireless network. Beacon Interval value determines the time interval of the
beacons. You can specify a value between 40-1000 milliseconds. The default value
is 100.
• RTS Threshold - Here you can specify the RTS (Request to Send) Threshold. If the
packet is larger than the specied RTS Threshold size, the router will send RTS
frames to a particular receiving station and negotiate the sending of a data frame.
The default value is 2346.
• Fragmentation Threshold - This value is the maximum size determining whether
packets will be fragmented. Setting the Fragmentation Threshold too low may
result in poor network performance since excessive packets. 2346 is the default
setting and is recommended.
• DTIM Interval - This value determines the interval of the Delivery Trac Indication
Message (DTIM). You can specify the value between 1-15 Beacon Intervals. The
default value is 1, which indicates the DTIM Interval is the same as Beacon Interval.
• Enable Short GI - This function is recommended for it will increase the data capacity
by reducing the guard interval time.
• Enable Client Isolation - Isolate all connected wireless stations so that wireless
stations cannot access each other through WLAN. This function will be disabled if
WDS/Bridge is enabled.
• Enable WMM - WMM function can guarantee the packets with high-priority
messages being transmitted preferentially. It is strongly recommended enabled.
To Next Page
Loading...
Need help?
General
