SERVICING
1 2 3
4
Servicing Procedure:13.1
Disconnect/isolate the oven from the power 13.1.1
supply.
Check the oven is correctly installed as 13.1.2
described in the Installation Instructions (Product
Details section).
Visually check the cleanliness/condition of the 13.1.3
power supply/cable/gland, oven casing, cavity and
door for signs of wear, damage, distortion etc., if
required, refer to the ‘Spares & Replacement’ section.
Complete an ‘Earth/Insulation test’ (Testing 13.1.4
Components section) on the oven before switching
on.
Check the display for Error messages, if 13.1.5
an Error is shown, refer to ‘Errors & Diagnostics’
(Servicing section).
Note; If a Firmware update is required, follow 13.1.6
the instructions under ‘Firmware Updates’ (Servicing
section) before continuing with the service
procedure.
Enter Service mode:13.2
On start up, tap the top right of the main menu 1
screen to bypass oven preheat.
Enter the authorised user password, for
2
example, MANAGER and select OK to display the
Settings menu.
Select the spanner symbol.
3
Enter the service password, for example SERVICE 4
on the keyboard and select OK to display the
error log, service information and test options.
Check the Error Log for details of any logged 13.2.1
oven errors. See ‘Errors & Diagnostics’ (Servicing
section) for more details.
Check the ‘Oven Counters’ to nd the usage 13.2.2
of components and the Controls area temperature
within the cabinet. (‘Errors & Diagnostics’, Servicing
section).
Check the operational performance of the 13.2.3
main components using the Visual or Data View
(‘Errors & Diagnostics’, Servicing section).
Perform the Oven tests, (Testing Components 13.2.4
section). If required refer to the ‘Spares and
Replacement’ section for any repairs needed before
continuing with the Oven Tests.
Follow the procedures under the 13.2.5
‘Commissioning’ section before commissioning the
oven for use.
SERVICING THE OVEN13
DANGER:
BEFORE REMOVING THE OVEN CASING, ISOLATE THE
OVEN FROM THE MAINS ELECTRICITY POWER SUPPLY;
SWITCH OFF, DISCONNECT OVEN PLUG FROM WALL
SOCKET, TURN OFF ISOLATOR SWITCH TO DISCONNECT
FIXED WIRED OVENS AND LOCKOFF.
WARNING:
ALLOW OVEN TO COOL AND OBSERVE AND FOLLOW ALL
SAFETY PRECAUTIONS INCLUDING THOSE DESCRIBED
UNDER THE SAFETY REGULATIONS SECTION OF THIS
MANUAL BEFORE ATTEMPTING A SERVICE OR REPAIR.
CAUTION MICROWAVE EMISSIONS:
DO NOT BECOME EXPOSED TO EMISSIONS FROM THE
MICROWAVE GENERATOR OR PARTS CONDUCTING
MICROWAVE ENERGY.
To Next Page
Loading...
Need help?
General
