11
Programming the Scanner
8110/8150/8250/8310/8312
To program the 8110/8150/8250/8310/8312, you must
scan a series of programming barcode in the correct
order. Fold out the back cover of this manual. You will see
a table of alphanumeric barcodes, which are used to
program the various options presented.
To program each option, you must:
1. Scan the Program barcode on the parameter setting
part.
2. Enter the option mode by scanning the Option Bar
Code (also on the Parameter setting part).
3. To the right of the option barcode, the necessary
alphanumeric inputs are listed. Scan these
alphanumeric entries from the back fold out page. To
confirm above steps, you must scan the Finish
barcode on the back fold out page.
4. Once you have finished programming. Scan the Exit
barcode, listed on the lower right hand corner of each
parameter setting part.
To Next Page
Loading...
