28
Scan
Scanning mode:
Good-read off-The trigger button must be pressed to
activate scanning. The light source of scanner stops
scanning when there is a successful reading or no code is
decoded after the Stand-by duration elapsed.
Momentary-The trigger button acts as a switch. Press
button to activate scanning and release button to stop
scanning.
Alternate-The trigger button acts as a toggle switch.
Press button to activate or stop scanning.
Timeout off-The trigger button must be pressed to
activate scanning, and scanner stops scanning when no
code is decoded after the Stand-by duration elapsed.
Continue-The scanner always keeps reading, and it does
not matter when trigger button is pressed or duration is
elapsed.
Double read timeout: If the barcode has been scanned
twice, then only the first barcode will be accepted.
Double confirm: If it is enabled, the scanner will require
a several times successful decoding to confirm the
barcode data. The more confirming times required the
more inhibitive miss-reading code will be shown. If you
set Double confirm, the Multi field scan Enable function
won’t be able to work.
Global min./max. code length: Global Minimum and
Maximum length can be set to qualify data entry. The
length is defined as the actual barcode data length to be
sent. Label with length exceeds these limits will be
rejected. Make sure that the Minimum length setting is no
greater than the Maximum length setting, or otherwise
the labels of the symbology will not be readable. In
particular, you can set the same value for both Minimum
and Maximum reading length to force the fixed length
barcode decoded. The values of setting have no effect on
To Next Page
Loading...
