Metrohm 860 KF - Default Chapter; Table of Contents

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
Table of contents
860 KF Thermoprep
￭￭￭￭￭￭￭￭
III
Table of contents
1 Introduction 1
1.1 Instrument description ......................................................... 1
1.1.1 Instrument components .......................................................... 1
1.1.2 Intended use ........................................................................... 2
1.2 About the documentation ................................................... 2
1.2.1 Symbols and conventions ........................................................ 2
1.3 Safety instructions ................................................................ 3
1.3.1 General notes on safety ........................................................... 3
1.3.2 Electrical safety ........................................................................ 3
1.3.3 Personnel safety ...................................................................... 4
1.3.4 Flammable samples and solvents ............................................. 5
1.3.5 Recycling and disposal ............................................................. 5
2 Overview of the instrument 6
3 Installation 8
3.1 Setting up the instrument .................................................... 8
3.1.1 Packaging ................................................................................ 8
3.1.2 Checks .................................................................................... 8
3.1.3 Location .................................................................................. 8
3.2 Connecting the mains cable ................................................. 8
3.3 Mounting the guidance rod ................................................. 9
3.4 Mounting the sample insert .............................................. 12
3.5 Mounting the needles ........................................................ 13
3.6 Mounting the heating tubing ............................................ 14
3.7 Mounting the dust filter .................................................... 16
3.8 Assembling the drying flask .............................................. 16
3.9 Air/nitrogen connector ....................................................... 18
3.10 Inserting the heating tube into the KF titration cell ....... 19
4 Operation 22
4.1 Switching the instrument on and off ............................... 22
4.2 The keypad .......................................................................... 22
4.3 The display .......................................................................... 23
4.3.1 Display elements .................................................................... 23
4.3.2 Status display ........................................................................ 23
4.3.3 Error messages ...................................................................... 24