3.6 Connecting the 920 Absorber Module to the remaining components
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
16
￭￭￭￭￭￭￭￭
Combustion-IC-System
3.6.1 Connecting the Combustion Module (AJ) inlet: water infeed
Connecting the capillary for the water infeed at the inlet of
the combustion tube
1
Feeding the capillary into the Combustion Module (AJ)
Feed the capillary with the blue colored sleeve into the inside
through the round opening up on the left side wall of the Combus-
tion Module (AJ) and route it to the right side of the Combustion
Module (see Chapter "Installing the Combustion Module after trans-
portation or storage" in the Combustion Module operating instruc-
tions).
2
Shortening the capillary
Shorten the capillary using the capillary cutter so that it can be con-
nected to the combustion tube's inlet easily.
3
Connecting the capillary
Three connections are located at the combustion tube's inlet:
To Next Page
Loading...
