MICRO-EPSILON optoCONTROL CLS-K-10 - Notes on CE Identification

Page 6
Safety
optoCONTROL CLS-K
1.3 Notes on CE Identification
The following applies to the optoCONTROL CLS-K: EMC regulation 2004/108/EC
Products which carry the CE mark satisfy the requirements of the EMC regulation 2004/108/EC ‘Electromag-
netic Compatibility’ and the European standards (EN) listed therein. The EC declaration of conformity is kept
available according to EC regulation, article 10 by the authorities responsible at
MICRO-EPSILON Eltrotec GmbH
Manfred-Wörner-Straße 101
73037 Göppingen / Germany
The sensor is designed for use in industrial and residential areas and satisfies the requirements of the stan-
dards
- EN 61000-6-3: 2011-09
- EN 61000-6-2: 2006-03
- EN 61000-4-2: 2009-12
- EN 61000-4-3: 2011-04
- EN 61000-4-4: 2013-04
- EN 61000-4-5: 2007-06
- EN 61000-4-6: 2009-12
- EN 61000-4-11: 2005-2
- EN 55011: 2011-04
The system satisfies the requirements if they comply with the regulations described in the instruction manual
for installation and operation.