Microhard Systems IPn4Gii - AT Commands for UDP Protocols

© Microhard Systems Inc. 161
5.0 AT Command Line Interface
AT+MCTUPMP1
Command Syntax
Set UDP Point-to-Multipoint as point parameters
when IP Protocol Mode is set to UDP Point-to-
Multipoint (P)
AT+MCTUPMP1=<Multicast IP>, <Multicast
Port>, <Listener Port>, <Time to live>
Description
Example
Input:
AT+MCTUPMP1=224.1.1.2,20002,20012,1<enter>
Response:
OK
AT+MCTUPMM1
Command Syntax
Set UDP Point-to-Multipoint as MP parameters when
IP Protocol Mode is set to UDP Point-to-Multipoint
(MP)
AT+MCTUPMM1=<Remote IP>, <Remote Port>,
<Multicast IP>, <Multicast Port>
Description
Example
Input:
AT+MCTUPMM1=0.0.0.0,20012,224.1.1.2,20002<enter>
Response:
OK
AT+MCTUMPMP1
Command Syntax
Set UDP Multipoint-to-Multipoint parameters when
IP Protocol is set to UDP Multipoint-to-Multipoint
mode.
AT+MCTUMPMP1=<Multicast IP>, <Multicast
Port>, <Time to live>, <Listen Multicast IP>,
<Listen Multicast Port>
Description
Example
Input:
AT+MCTUMPMP1=224.1.1.2,20012,1,224.1.1.2,20012<enter>
Response:
OK