Micromeritics GEOPYC 1365 - Page 37

The data in this report can be used to make comparisons between samples and comparisons of
samples against your standards or specifications. It can also be used to ensure that an adequate
amount of sample was contained in the sample bed. To ensure reproducible results, at least 25% of
the sample bed should be actual sample.
If absolute density data was entered, percent porosity and specific pore volume are reported. If a
zero depth set number was entered, the percent sample volume is reported.
Envelope Density Report
GeoPyc 1365 Operator Manual
136-42800-01 (Rev -) — Dec 2016
3 - 9