Micron Electronics, Inc. 3-27
Chapter 3: The BIOS Setup Program
Load Custom Defaults
Loads the custom defaults for Setup options
Save Custom Defaults
Saves the current values as custom defaults. Normally, the BIOS reads the
Setup values from flash memory. If this memory if corrupted, the BIOS reads
the custom defaults. If no custom defaults are set, the BIOS reads the factory
defaults.
Discard Changes
Discards any changes made up to this point in Setup without exiting Setup.
This selection loads the CMOS RAM values that were present when the
computer was turned on.
To Next Page
Loading...