2-2 Micron Electronics, Inc.
Micron ClientPro 766Xi/Xe User’s Guide
Overview
Micron's ClientPro 766Xi/Xe features a high-performance system board
designed to be the basis for your personal computer or workstation. The
ClientPro 766Xi/Xe is based on the PCI local bus and the Intel 440LX chip set.
System Features
o ATX form factor.
o Two ISA slots, three PCI local bus slots with one ISA/PCI slot
being shared. Slot 1 for Klamath processor card.
o One accelerated graphics port. Two USB (Universal Serial Bus)
ports.
o 512K L2 Synchronous Cache support.
o Support for up to 384MB of ECC or non-ECC on-board system
SDRAM memory.
o Support for Ultra DMA/33. IDE Mode 4 support.
o Two high-speed 16550 compatible serial ports.
o Bidirectional parallel port that is EPP (Extended Parallel Protocol)
and ECP (Extended Capabilities Port) compatible.
o lntel’s 440LX chip set.
o Integrated PCI bus mastering controller.
o Three 168-pin DIMM sockets.
o Floppy controller for two floppy drives (Supports 2.88MB,
1.44MB, 1.2MB, 720KB, and 360KB floppy drives).
o 2MB Flash Phoenix EEPROM BIOS.
o Management Extension Component (LM79) which provides low-
cost instrumentation capabilities designed to reduce the total cost
of owning a PC when used with LANDesk Client Manager.
Features include: an integrated temperature sensor; fan speed
sensors; power supply voltage monitoring; and remote reset
capabilities from a remote peer or server through LANDesk
Client Manager.
To Next Page
Loading...