iv MS-4 Imager User’s Manual
Table of Contents
Table of Contents
Chapter 1 Quick Start
Step 1 Check Required Hardware........................................................... 1-2
Step 2 Connect the System..................................................................... 1-3
Step 3 Position Imager and Symbol ........................................................ 1-4
Step 4 Install ESP ................................................................................... 1-5
Step 5 Select Model ................................................................................ 1-6
Step 6 Select Communications Protocol................................................. 1-7
Step 7 Locate the Symbol in the FOV..................................................... 1-8
Step 8 Calibrate Settings....................................................................... 1-10
Step 9 Test Read Rate.......................................................................... 1-11
Step 10 Configure the Imager in ESP ................................................... 1-12
Step 11 Make Menu Changes and Save in ESP................................... 1-13
Chapter 2 Using ESP
EZ Mode.................................................................................................. 2-2
Application Mode..................................................................................... 2-3
Menu Toolbar .......................................................................................... 2-4
Connecting ........................................................................................... 2-12
View...................................................................................................... 2-13
Navigating in ESP ................................................................................ 2-14
Send/Receive Options.......................................................................... 2-15
Using EZ Trax ....................................................................................... 2-17
Chapter 3 Communications
Communications by ESP......................................................................... 3-2
Communications Serial Commands........................................................ 3-3
Host Port Connections ............................................................................ 3-4
Host Port Protocol ................................................................................... 3-5
ACK/NAK Options ................................................................................... 3-7
Polling Mode Options .............................................................................. 3-8
RS-422 Status ......................................................................................... 3-9
Auxiliary Port Connections .................................................................... 3-10
Auxiliary Port System Data Status ........................................................ 3-18
Daisy Chain Autoconfigure.................................................................... 3-19
Response Timeout ................................................................................ 3-20
LRC Status ............................................................................................ 3-21
Protocol Configuration Examples .......................................................... 3-22
USB HID Interface................................................................................. 3-23
ASCII Character Entry Modifier............................................................. 3-32
Preamble ............................................................................................... 3-33
Postamble ............................................................................................. 3-34
Chapter 4 Calibration
Calibration Serial Commands.................................................................. 4-2
To Next Page
Loading...
