Microscan MS-4 - Page 97

MS-4 Imager User’s Manual 5-1
5 Read Cycle
Contents
After you’ve established communications and completed basic read rate testing, you will
need to address the spatial and timing parameters associated with your application. This
section explains those parameters.
Read Cycle by ESP ...................................................................................................................... 5-2
Read Cycle Serial Commands......................................................................................................5-3
Read Cycle Setup......................................................................................................................... 5-4
Multisymbol...................................................................................................................................5-5
Trigger Mode and Duration...........................................................................................................5-6
External Trigger Polarity ............................................................................................................. 5-11
Serial Trigger .............................................................................................................................. 5-12
Start Trigger Character (Non-Delimited).....................................................................................5-13
Stop Trigger Character (Non-Delimited)..................................................................................... 5-13
End of Read Cycle...................................................................................................................... 5-14
Capture Mode.............................................................................................................................5-16
Capture Timing ...........................................................................................................................5-20
Image Processing Timeout......................................................................................................... 5-22
Image Storage ............................................................................................................................ 5-23
Minimum Good Reads ................................................................................................................ 5-25
Setting Up the Imager for EZ Trax..............................................................................................5-26