Microsemi SyncServer S250i - Halting the SyncServer

Halting the SyncServer
Also see Stratum (on page 181).
Halting the SyncServer
Microsemi recommends shutting the operating system down before removing the power.
Using the keypad/display interface:
1.
Press the MENU button.
2.
Select 3) Shutdown.
3.
Select 1) Yes.
4.
Press the ENTER button.
5. When the display shows "System Stopped - OK to Turn Power Off Now!" turn the power
off.
Or, using the web interface:
1.
Go to the SERVICES - Startup page.
2.
Select Halt and click the APPLY button.
3. Wait approximately 30 seconds before removing power.
997-01520-02 Rev. G2.......................................................................... Page 15