Web Interface
WIZARDS Tab
Select a topic from below to learn more about the WIZARDS features of the Web Interface:
WIZARDS-1stSetup
Microsemi strongly recommends using the 1st Setup to perform the initial configuration of the
SyncServer.
1st Setup guides the operator through the following procedures:
n Setting a new password
n Enabling Password Recovery (optional)
n Configuring the IP address, hostname, and DNS for <LAN*>.
n Setting the local time zone (optional)
WIZARDS-NTP
Microsemi recommends using this wizard to perform an initial NTP configuration of up to 5
server associations.
To modify an existing NTP configuration, use the NTP - Config page instead.
Note: This Wizard deletes all NTP associations that are not server associations.
Also see: NTP - Config and NTP - MD5 Keys.
WIZARDS-SNMP
Use the SNMP wizard to add or change the following SNMP v1/v2c settings:
n Set SysLocation, SysContact and SysName
n Set the Read and Write Community Strings
n Add up to four v1/v2c Trap Destinations
Advanced SNMP configuration (e.g., SNMP v3) is performed on the NETWORK - SNMP and
NETWORK - Traps pages. Upon completing the Wizard, the new SNMP settings replace the
previous ones and the SNMP daemon restarts.
See also NETWORK - SNMP (on page 31) and NETWORK - SNMP Traps (on page 32).
WIZARDS-Backup
The Backup wizard guides the operator through saving the SyncServer’s current con-
figuration to nonvolatile memory in the SyncServer, and optionally transfers the backup con-
figuration to a remote location. The backup file can be used to:
n 'Clone' the configuration to other SyncServers with the same Software Version.
n Restore the SyncServer's configuration if it is lost or becomes unusable.
Page 70..........................................................................997-01520-02 Rev. G2
To Next Page
Loading...
