24 Port Gigabit Ethernet PoE Switch – User Manual Page 22 of 72
________________________________________________________________________
©2014 MICROSENS GmbH & Co. KG – Hamm/Germany www.microsens.com
Parameter description
System Description:
The simple description of this switch
Firmware Version:
The firmware version of this switch
Hardware Version:
The hardware version of this switch
MAC Address:
It is the Ethernet MAC address of the management agent in this switch.
Serial Number:
The serial number is assigned by the manufacturer.
Active IP Address:
Show the active IP address of this switch.
Active Subnet Mask:
Show the active subnet mask of this switch.
Active Gateway:
Show the active gateway of this switch.
DHCP Server:
Show the IP address of the DHCP server.
Default: 0.0.0.0
Lease Time Left:
Show the lease time left of DHCP client.
Device Name:
Set a special name for this switch. Up to 16 characters are allowed in this pa-
rameter. Any alphanumeric character and null are acceptable.
Default: Giga Switch
System Contact:
The textual identification of the contact person for this managed node, together
with information on how to contact this person. The allowed string length is 0 to
255, and the allowed content is the ASCII characters from 32 to 126.
System Location:
This entry informs about the physical location of this node. The allowed string
length is 0 to 255, and the allowed content is the ASCII characters from 32 to
126.
DHCP Enabled:
Enable DHCP snooping, just tick the check box () to enable it. If this function
is enabled the IP settings are automatically assigned by a DHCP server. Please
ensure that a DHCP server is available via the network.
Default: disabled
Fallback IP Address:
Users can configure the IP settings and fill in new values. Then, click <Apply>
button to update.
Default: 192.168.1.1
To Next Page
Loading...
Need help?
General
