To Next Page

To Previous Page

24 Port Gigabit Ethernet PoE Switch – User Manual Page 68 of 72

________________________________________________________________________

4. Maintenance

4-1. Resolving No Link Condition

The possible causes for a no link LED status are as follows:

 The attached device is not powered on

 The cable may not be the correct type or is faulty

 The installed building premise cable is faulty

 The port may be faulty

 Mismatch of Auto-Negotiation settings

4-2. Q&A

1. Computer A can connect to computer B, but cannot connect to computer C through

this switch.

 The network device of computer C may fail to work. Please check the link/act sta-

tus of computer C on the LED indicator. Try another network device on this connec-

tion.

 The network configuration of computer C may be something wrong. Please verify

the network configuration on Computer C.

2. The uplink connection function fails to work.

 The connection ports on another must be connection ports. Please check if connec-

tion ports are used on that switch.

 Please check the uplink setup of the switch to verify the uplink function is enabled.

3. The console interface cannot appear on the console port connection.

 This switch has no console port.

4. How to configure the 24 Port Gigabit Ethernet PoE Switch.

 User can use IE browser program in window series of computer to control the web

smart functions in the switch. First, choose any port of the switch and connect the

device with your network. Then, use IE and type default IP address, 192.168.1.1.

Finally, the login screen will appear at once.

Microsens MS400863M User Manual

Other manuals for Microsens MS400863M