To Next Page

To Previous Page

24 Port Gigabit Ethernet PoE Switch – User Manual Page 32 of 72

________________________________________________________________________

Parameter description

PoE Enabled:

PoE can be enabled or disabled for each port separately.

Priority:

Three options are offered for the user to choose, including Normal, Low and High.

Default is Normal. The switch will stop supplying the power to the port based on

the order of the priority LowNormalHigh in case total power required by all

PDs linked to the switch excesses the power limit. As the ports have the same

priority, then the switch will cease the power supplement from the port with the

highest port id (121).

Allocation (W):

The power is consumed by the port.

Detection:

The detection represents the PoE capacitor detection for the port.

Legacy: Legacy capacitive detection only

4-point: IEEE 802.3af 4-point detection only

Both: IEEE 802.3af 4-point detection followed by Legacy detection

Delay time:

The delay time is using for set the time period for PD PoE enable time delay pe-

riod. It is a solution to avoid rush current to cause shorter PD. The available time

period is from 0 to 300 seconds and 0 means disable the function

Reset Port:

To reset the port PoE configuration and status

Microsens MS400863M User Manual

Other manuals for Microsens MS400863M