True when S/C trimming, O/C trimming, or calibration measurement is completed.
Set true when single shot measurement is completed.
Other bits are uncommitted and are always 0
6.1.7 Common Commands
Common commands are listed below. Their detailed description will be given later.
Clears the Event Status Register and associated status
data structure.
Sets the Event Status Enable Register to the value of the
data following the command.
Event Status Enable Query
Returns the current contents of the Standard Event Status
Enable Register as an integer in the range 0 to 255.
Event Status Register Query
Returns the current contents of the Standard Event
Status Register as an integer in the range 0 to 255. It also
clears ESR.
Sets the Service Request Enable Register to the value
following the command. The register is set except that bit
6 is ignored.
Service Request Enable Query
Returns the current contents of the Service Request Enable
Register as an integer in the range 0 to 63 and 128 to 255.
Returns the current contents of the Status Byte with the
Master Summary bits as an integer in the range 0 to 255.
Bit 6 represents Master Summary Status rather than
Request Service.
Returns the data identifying the instrument. (e.g. the data output
will be: ‘Microtest,6375 Series,0,1.0’ where the first field is the
manufacturer, then the model number, then a zero and the
software revision number: here represented as Issue 1.0).
Resets the instrument to a default setting. This command
is equivalent to a power-up reset.
Triggers a direct measurement, but does not return the
results to the controller. This is the same as a GET
(Group Execute Trigger) command.
Option Identification Query
Returns the hardware options installed in the instrument.
To Next Page
Loading...
