Microtest 6375 - Page 52

6–14
Command
Summary
Page
:MEAS:NOMinal?
Nominal query.
6-23
:MEAS:LIMIT <disc>
Set percentage or absolute scale limits.
6-24
:MEAS:LIMIT?
Limit type query.
6-24
:MEAS:HIgh-LIMit <real>
Set scale high limit.
6-24
:MEAS:HIgh-LIMit?
High limit query.
6-24
:MEAS:LOw-LIMit <real>
Set scale low limit.
6-25
:MEAS:LOw-LIMit?
Low limit query.
6-25
:MULTI
Select multi-step mode / path.
6-26
:MULTI:SET
Switch to the multi-step set-up page.
6-26
:MULTI:RUN
Switch to the multi-step run page.
6-26
:MULTI:TEST
Select the step to edit.
6-27
:MULTI:TEST?
Return the number of the step that is currently being edited.
6-27
:MULTI:FUNC <disk>
Set measurement type for the currently selected step.
6-27
:MULTI:FUNC?
Returns the measurement type of the currently selected step.
step.
6-27
:MULTI:FREQuency <real>
Set the frequency for the currently selected step.
6-28
:MULTI:FREQuency?
Returns the frequency of the currently selected step.
6-28
:MULTI:LEVel <real>
Set the drive level for the currently selected step.
6-28
:MULTI:LEVel?
Returns the drive level of the currently selected step.
6-28
:MULTI:SPEED <disk>
Set the measurement speed for the currently selected step.
6-29
:MULTI:SPEED?
Query the measurement speed of the currently selected step.
6-29
:MULTI:HIgh-LIMit <real>
Set the higher test limit of the currently selected step.
6-29
:MULTI:HIgh-LIMit?
Returns the high limit value of the currently selected step.
6-29
:MULTI:LOw-LIMit <real>
Set the lower test limit of the currently selected step.
6-30
:MULTI:LOw-LIMit?
Returns the low limit value of the currently selected step.
6-30
:MULTI:DELAY <real>
Set trigger delay time for currently selected step.
6-30
:MULTI:DELAY?
Returns the trigger delay time of the currently selected step.
6-30
:MULTI:DEL
Remove the current step.
6-30
:MULTI:TRIGger
Starts a run of multi-step measurements.
6-31
:MULTI:RES?
Query the results of the multi-step test.
6-31