Part name: 1 – sprayer holder 2 – nut of sump assembly
10. Turn cover of water softener. Contrarotate nut of air breather. Contrarotate nut of siphon,
then take out one way valve from siphon. Contrarotate nut of sump assembly.
Part name: 1 – nut of air breather 2 – nut of siphon
3 – nut of water softener 4 – nut of sump assembly
11. Take out door springs and connecting lines for connecting spring to door assembly.
12. Remove all screws for fixing right and left front chamber bracket. Take out the tank
assembly, at the same time unfix the snap-fits of bottom board for fixing right and left front
chamber bracket.
Part name: 1 – springs 2 – connecting lines
3 – right front chamber bracket
4 – left front chamber bracket
13. Reverse the above procedure to install. And check out all connectors connects well.
Sump assembly
1
Screws
2
1
2
Snap-fits
Screws
3 4
1
2
3
4
To Next Page
Loading...
Need help?
General
