COMMUNICATION
37
3
SYSTEM
37
4
PERSONALIZE
37
5
This parameter is used to specify a period after which the device is put in
sleep mode if no operation within this period. You can wake up the device
from sleep by pressing any key or touching the screen.
Numerical range in 30 minutes, the factory default for 30 minutes.
This parameter is used to set the picture cycle interval This parameter can be either disabled or ranges from 30 s to 999s.
This parameter is used to set the picture cycle interval This parameter can be either disabled or ranges from 30 s to 999s.
To Next Page
Loading...