Midmark 630 - Page 20

English-20
004-1055-00
TP210 Rev. A
© 2013 Midmark Corp. | 60 Vista Drive Versailles, OH 45380 USA | 1-800-643-6275 | 1-937-526-3662 |
[Revised: mo/dd/yr]
ID Code 02 (Base / Power Supply Board) - continued
Error Code Error Denition Probable Cause Correction
0A
Overtravel Error
Loose wire connection.
Check and secure wire connections at J5 on Power Supply PC Board and
at Overtravel limit switch. Refer to: Fuses and Connections
Disconnect power cord for at least ve seconds, then plug back in.
Overtravel limit switch.
Test / Replace switch. Refer to: Base Actuator / Limit Switches
Disconnect power cord for at least ve seconds, then plug back in.
0b
Hall Sensors
Loose wire connection.
Check and secure hall sensor wire connection at J7 on Power Supply PC Board.
Refer to: Fuses and Connections
Motor Failure. Replace Base actuator motor.
0C
Motor Current Excessive load on actuator.
Check / Reduce patient load. (650 lb. Maximum)
Check mechanical structure for binding.
0d
Motor Run On Error
The motor has been detected moving for a longer period of
time than the run-on time allows.
Check actuator / motor and limit switches.
0E
Motor Stall Error
Excessive load on actuator.
Check / Reduce patient load. (650 lb. Maximum)
Check mechanical structure for binding.
Loose wire connection.
Check and secure wire connections at J6 on Power Supply PC Board.
Refer to: Fuses and Connections
0F
Motor Direction Error
The motor is being commanded to move in one direction,
but is actually moving in another.
Check actuator / motor.
10
Communication Error to
Machine Control
Message / Communication failure.
Error goes away by itself.
Disconnect power cord for at least ve seconds, then plug back in.
11
Corrupt Memory Last save to memory failed.
Disconnect power cord for at least ve seconds, then plug back in.
Replace Power Supply PC Board.
12
Memory Save Error Saving to memory failed.
Disconnect power cord for at least ve seconds, then plug back in.
Replace Power Supply PC Board.
13
Memory Recall Error Recalling information from memory failed.
Disconnect power cord for at least ve seconds, then plug back in.
Replace Power Supply PC Board.
14
Memory Erase Error Erasing information from memory failed.
Disconnect power cord for at least ve seconds, then plug back in.
Replace Power Supply PC Board.
15
I2C Slave Not Present Power Supply PC Board fuse blown.
Disconnect power cord for at least ve seconds, then plug back in.
Test / Replace F5 fuse on Power Supply PC Board.
16
I2C Slave Not Initialized Power Supply PC Board fuse blown.
Disconnect power cord for at least ve seconds, then plug back in.
Test / Replace F5 fuse on Power Supply PC Board.
midmark.com
Style A