Midmark IQecg - Software Installation

14
48-78-0002
© Midmark Corporation 2016
Go to Table of Contents
Software Installation
The medical diagnostic application IQecg
®
uses IQmanager
®
to manage patient records. When installing or upgrading the IQecg
®
,
IQmanager
®
may also need to be installed or upgraded accordingly (refer to the IQmanager
®
Operation Manual for further
information).
Other Midmark products can also be accessed from IQmanager
®
, such as, IQholter
®
, IQspiro
®
, IQvitals
®
, IQvitals
®
PC, and Weight/Scale
Interfaces. Contact the Midmark Sales Department for the latest information on available Midmark products, or visit midmark.com.
Before installing IQmanager
®
on a computer, it is important to understand and carry out task described on the following pages:
Note
The foregoing specification is the minimum computer requirement
specification for operating the IQecg
®
through IQmanager
®
. A faster
CPU and/or more memory may be required if you planning to
operate the IQecg
®
through an EMR or install additional software.
Note
USB ports/contacts can become worn with repeated use. The
IQecg
®
test may not function with a worn USB port.
Note
The following software installation information refers to
IQmanager
®
only. If using the IQecg
®
through an EMR, please
contact Midmark Technical Service for assistance with installation
and setup.
Note
If IQmanager
®
is already installed on the computer and you are
now either upgrading or adding a new Midmark product, please
skip
this section and refer to the IQmanager
®
Operation Manual
for installation information.