Midmark IQecg - IQmanager Installation Steps

15
48-78-0002
© Midmark Corporation 2016
Go to Table of Contents
Screen Saver
If a screen saver or any energy-saving feature is enabled on the computer, make sure that it does not activate and interfere with data
acquisition during patient care. Refer to your computer or software manual for these settings.
Installation Steps for IQmanager
®
1. Double-click the IQmanager® setup file. The installation starts automatically.
2. Once the installation is complete, connect the IQecg
®
module to the computer with the steps outlined in the following section.
3. If there are any new licenses, add them to the licensing server.
For any questions on the installation please refer to the IQmanager
®
Operation Manual.
Note
The Midmark IQecg
®
requires software to operate. The
following instructions use the IQmanager
®
software. Please
contact Midmark at 1-800-624-8950 to purchase the required
software license.
Note
Close all Windows
®
programs before running this software
installation. Do not interrupt the installation program while it is
running. The installation should take less than five minutes.
Note
Do not connect any devices to the computer before running the
software installation.