Midtronics DSS-5000 HD

Midtronics Inc. 7000 Monroe Street Willowbrook, IL 60527
www.midtronics.com
5
Chapter 1: IntroductionDSS-5000 HD
Personal Precautions
Risk of explosive gases.
Never smoke or allow a spark or
ame in the vicinity of a battery.
Batteries can produce a highly explosive mix
of hydrogen gas and oxygen, even when the
battery is not in operation. Always work in a
well-ventilated area.
Wash hands after handling.
REQUIRED BY CALIFORNIA PROP. 65: Battery posts,
terminals, and related accessories contain lead and lead
compounds, chemicals known to the state of California to
cause cancer and birth defects or other reproductive harm.
Inspect the battery for damage and check the electrolyte level.
If the electrolyte level is too low, replenish it and fully charge
the battery. Always use the necessary safety precautions when
working with batteries to prevent severe injury or death.
Follow all manufacturers’ instructions and BCI (Battery Council
International) safety recommendations, which include the
following precautions:
9 Battery acid is highly corrosive. If acid enters your eyes, im-
mediately ush them thoroughly with cold running water
for at least 15 minutes and seek medical attention. If bat-
tery acid gets on your skin or clothing, wash immediately
with a mixture of water and baking soda.
9 Always wear proper safety glasses or face shield when
working with or around batteries.
9 Keep hair, hands, and clothing as well as the analyzer
cords and cables away from moving engine parts.
9 Remove any jewelry or watches before you start servicing
the battery.
9 Use caution when working with metallic tools to prevent
sparks or short circuits.
9 Never lean over a battery when testing, charging, or jump
starting.
Symbols Conventions
Symbol Description
!
The safety symbol indicates instructions for
avoiding hazardous conditions and personal injury.
The safety symbol with the words CAUTION,
WARNING, or DANGER indicates instructions for
avoiding hazardous conditions and personal injury.
The wrench symbol indicates procedural notes and
helpful information.
Accessories
A033
Lead Post Adapter Set (4)
A401
Paper Roll-10 Pack
A422
DSS-5000 HD Wall Charger
A423
Printer Module
A657
Amp Clamp
(Optional*)
* - For Amp Clamp-ready testers only
A658
USB to micro-USB cable
DSS-5003
Charging/Storage Dock
A823
DSS-5000 HD Replacement
DMM Test Cables
A825
DSS-5000 HD 3 Meter
Replacement Battery Test Cables
Chapter 1: Introduction