Miele DGC 6300 - Sequence of an Automatic Programme; Changing Settings During a Cooking Programme

Operation: Steam cooking
36
Sequence of an automatic
programme
Up until the start the function, the
selected temperature, Start at and the
start time will appear in the display.
After the start time you can see the
temperature increasing in the display
during the heating-up phase until the
set temperature is reached. Once this
temperature is reached a tone will
sound.
After the heating-up phase you can
follow the time counting down in the
display. The last minute counts down in
seconds.
At the end of the programme the
steam generator will switch off. A tone
or melody will sound (see "Settings -
Acoustic tones").
Steam reduction (only with temperatures
over approx. 80°C) and Prog. finished
will appear in the display.
You have the option of saving your
settings as a User programme (see
"User programmes") or increasing the
cooking duration via .
Changing settings during a cooking
programme
 Touch .
The following will appear in the display:
– Temperature
– Duration
– Ready at
– Start at
If the temperature in the oven is too
high Ready at and Start at are not
displayed.
Changing the temperature
 Scroll through the list until
Temperature is highlighted.
 Confirm with OK.
 Change the temperature.
 Confirm with OK.
The programme will restart with the new
temperature.
You can permanently reset the
recommended temperature to suit
your personal cooking preferences.
(See "Settings - Recommended
temperatures").