Miele G 7804 - Add Salt Indicator Light Flashes; Neutralising Agent Indicator Light Flashes; Rinsing Agent Indicator Light Flashes; Liquid Cleaning Agent Indicator Light Flashes

Problem Possible cause Remedy
The Add salt indicator
light k flashes.
The salt reservoir has not
been replenished,
meaning that the water
softener could not be
reactivated.
–
Fill carefully with salt.
The neutralising agent
indicator light w
flashes.
The neutralising agent
container is empty.
–
Fill the container with
neutralising agent or
replace it with a new, full
container.
–
Vent the DOS module
where necessary.
The rinsing agent
indicator light H
flashes.
The rinsing agent
reservoir is empty.
–
Fill the reservoir with
rinsing agent.
The liquid cleaning
agent indicator light
8 flashes.
The liquid cleaning agent
container is empty.
– Fill the container with liquid
cleaning agent.
– Vent the DOS module
where necessary.
A few minutes after the
start of a programme,
the p / 6 indicator
flashes and the
programme is
cancelled.
Before trying to rectify the
problem, you must:
– Turn the programme
selector to f (the fault
code goes out).
–
Switch the dishwasher off
with the I-0 switch.
Fault code: F..E:
There is a water inlet
fault.
–
Open the stopcock.
–
Clean the water inlet filter.
–
The water pressure at the
intake is too low. Ask a
plumber for advice.
Then:
–
Switch the dishwasher on.
–
Start the programme
again.
Problem solving guide
54