Problem Possible cause Remedy
The programme is
cancelled and the
p / 6 indicator
flashes.
Before trying to rectify the
problem, you must:
–
Turn the programme
selector to f (the fault
code goes out).
–
Switch the dishwasher off
with the I-0 switch.
Fault code: F..A:
There is a water drainage
fault.
–
Clean the filters in the
wash cabinet.
–
Clean the drain pump.
–
Clean the non-return valve.
–
Remove any kinks and
straighten the drain hose.
Then:
– Switch the machine on.
– Drain the water.
– Start the programme
again.
Water in the wash
cabinet is not heated;
the programme lasts
too long.
Fault code: F01 - F02
This dishwasher has a
resettable heater limiter
which will switch off the
heating elements if they
over-heat. This could be
caused, for example, by
large articles covering the
heating elements or if the
filters in the wash cabinet
are blocked.
To rectify the problem:
– Clean the filters in the
wash cabinet.
–
Rearrange the load.
–
Reset the thermal cut-out
(see "Other problems,
Thermal cut-out").
Problem solving guide
55
To Next Page
Loading...
