EasyManuals Logo

Miele G 7881 Operating Instructions

Miele G 7881
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #57 background imageLoading...
Page #57 background image
Thermal cut-out
This machine has a resettable heater
limiter which will shut off the elements in
the event of over-heating. This could be
caused for example, by large articles
covering the heating elements or if the
filters in the wash cabinet are blocked.
If the fault code: F01 - F03, F18, F19
(water was not heated up in the wash
cabinet and the programme is taking
too long), proceed as follows:
^
Remove the cause of the fault.
^
Remove the service panel.
^ Press the reset button on the heater
limiter located on the right-hand side
of the plinth.
If this switch trips again, contact the
Miele Service Department.
Other problems
57

Table of Contents

Other manuals for Miele G 7881

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Miele G 7881 and is the answer not in the manual?

Miele G 7881 Specifications

General IconGeneral
BrandMiele
ModelG 7881
CategoryWasher
LanguageEnglish

Related product manuals