,
Use only special processing
chemicals for lab washers and
observe the manufacturer's
recommendations for use. In
particular, always observe the
manufacturer's instructions
regarding residual amounts that do
not pose any toxicological risk.
Adding rinse aid
Rinse aid is not used in laboratory
glassware cleaning applications.
If rinse aid is required, the rinse aid
dosage must be activated with
assistance from Miele Technical
Service.
Rinse aid (e.g., MieleClear) is filled in
the storage container, and the selected
dose is then dispensed automatically.
The rinse aid reservoir holds
approximately 180 ml.
,
Inadvertently filling the rinse aid
reservoir with detergent will damage
the lab washer. Be sure only to use
rinse aid in the rinse aid reservoir.
^
Open the machine door.
^ Unscrew the reservoir cap.
^
Pour enough rinse aid into the
reservoir so that the level indicator
(see arrow) is dark. Use a funnel if
necessary.
^
Replace and tighten the reservoir
cap.
^
Wipe up any spilled rinse aid, to
prevent over sudsing during the next
wash cycle.
Rinse Aid
17
To Next Page
Loading...
