Buzzer
The buzzer can be programmed for the following functions:
– a continuous tone at the end of a program,
– an error signal that beeps in 1-second intervals, and
– a sample-collection signal (allows a sample of the final rinse water to be
collected) that beeps in sets of 3 followed by a 2-sec pause. Contact Miele
Technical Service to program the sample-collection
signal.
The numbers shown in the display correspond to the following settings:
20 Buzzer off
21 End of program (factory setting)
22 Error
23 End of program + Error
24 Sample-collection signal
25 End of program + Sample-collection signal
26 Error + Sample-collection signal
27 All functions (End of program + Error + Sample-collection signal)
Step Display / Result
^ Press the "Drying" 0 button until E04 appears in the
display.
E04
^ Turn the program selector to "Inorganica".
21
^
Press and hold the "Display" ß button until the
required value appears in the display, e.g., 26.
26
Value selected:
The buzzer will sound for 30 sec during the selected setting.
To switch it off earlier:
–
Turn the program selector to f.
–
Press the "Display" ß button.
–
Interrupt the power supply, e.g., open the door.
Programming functions
43
To Next Page
Loading...
