End of a program
Once the "Start" indicator goes out, and
the "Complete" indicator comes on, the
program has ended. You will see a 0 in
the middle of the display, and all other
indicators will show a running light.
A buzzer sounds for a maximum of
30 seconds by default.
To change the buzzer function, see
"Programming functions".
^
Use the "Display" button to view the
total running time or temperature of
the program.
Immediately after a program has
finished, partially open the door of the
lab washer for 10 to 15 mins. A good
drying result is achieved by the residual
heat.
Turning off
^
Press and release the "On/Off"
button.
Because of the electric door lock, the
door can only be opened if the "On/Off"
button is pressed (see "Opening and
closing the door").
Use
36
To Next Page
Loading...
