Canceling a program
,
If a program is canceled it must
be run again to be complete.
Canceling a program because of an
interruption
The program is stopped prematurely
and a Fault message appears in the
display.
Depending on the cause the
appropriate measures must be taken to
correct the fault. See "Frequently asked
questions".
Manually canceling a program
Avoid canceling a running program
unless absolutely necessary, for
example if the labware is moving
around excessively or the wrong
program has been selected.
,
In cases of officially recognized
epidemics, contaminated water
must NEVER be drained from the lab
washer.
^
Turn the program selector to f.
The program is canceled after
2 seconds.
^
Open the door.
,
Caution! Water and items in the
lab washer may be hot. There is a
danger of burning or scalding.
^
Rearrange the items securely. Wear
protective gloves as needed, and
comply with all applicable health and
safety regulations for infectious
disease control.
^
Replenish powder detergent if
necessary.
^
Close the door.
^ Start the "Drain" program.
The water will be drained away.
^ Select and start the program.
Use
37
To Next Page
Loading...
