Please refer to the installation
diagram included with the lab
washer.
,
Furniture and fittings installed
near the lab washer must be of a
commercial standard, able to
withstand the effects of steam.
The lab washer must be in a stable and
level horizontal position.
Use the front screw feet to compensate
for unevenness in the floor, or to adjust
the height of the machine.
Installation options:
– Free-standing
– Slide-in:
Next to other machines or furniture,
or in a suitable space. The space
must be at least 23
5
/
8
" (60 cm) wide
and 23
5
/
8
" (60 cm) deep.
– Undercounter:
The machine can be installed under
a continuous countertop or sink
drainer.
The recess must be at least 23
5
/
8
"
(60 cm) wide, 23
5
/
8
" (60 cm) deep
and 32
5
/
16
" (82 cm) high.
Undercounter installation
To install the lab washer under a
continuous countertop, the machine lid
must be removed, as follows:
^
Open the door.
^ Remove the fixing screws on the left
and right hand sides.
^ Pull the machine lid forward approx.
1/4" (5 mm) lift it upwards and
remove.
Installation
68
To Next Page
Loading...
