Commissioning
21
Water hardness
The display changes to the screen for
setting the water hardness.
– The dishwasher must be
programmed to the correct water
hardness for your area.
– Your local water authority will be able
to advise you of the water hardness
level in your area.
– Where the water hardness fluctuates
e.g. between 10 - 16gr/gal (10 - 15
°d), always program the dishwasher
to the higher value (16gr/gal or 15 °d
in this example).
It is useful to know your water hardness
so that you can provide the service
technician with this information in the
event of any service calls.
Enter the water hardness below:
____________ gr/gal (°d)
The dishwasher is programmed at the
factory for a water hardness level of 16
gr/gal (15 °d).
Use the arrow buttons to select
the hardness of your water supply
and confirm with OK.
See “Settings menu, Water hardness”
for more information on setting the
water hardness.
Finally, the messages Miele@home
enabled and Set up complete will appear
in the display.
After confirming these messages with
OK, the messages Refill salt and
Refill rinse aid may appear.
Add salt and rinse aid if necessary
(see “Commissioning, Reactivation
salt” and “Rinse aid”).
Confirm the messages with OK.
The program selected will appear briefly
in the display and the appropriate
indicator light will come on.
The display will then show the
estimated program duration for the
program selected.
These basic settings will be saved after
the dishwasher has been through one
complete program.
To Next Page
