Operation
42
Turning the machine on
Make sure the spray arms are not
obstructed.
Close the door.
Turn on the water supply if it is turned
off.
Press the button for at least 2
seconds.
The program selected will appear briefly
in the display and the appropriate
indicator light will come on.
The display will then show the
estimated program duration for the
program selected.
The Start indicator light flashes.
Switch the Memory function on (see
“Settings menu, Memory”) if you want
the last program selected to remain
selected instead of the ECO program.
Selecting a program
Choose your program according to the
type of load and the degree of soiling.
The different programs and their uses
are described in the Program overview
later on in this booklet.
Use the program selection button
to select the program required.
The indicator light next to the program
selected will come on.
During the course of the program, you
can use OK to display the name of the
program which is currently running.
You can now select program options
(see “Program options”).
If any program options are selected, the
appropriate indicator lights will also
light up.
Starting a program
Press the Start or OK button.
The program starts.
The Start indicator light will come on.
A program should only be cancelled
in the first few minutes, if at all.
Important program stages could
otherwise be omitted.
To Next Page
Loading...
