Programme settings
101
Programme
blocks
Wash block sequence is predefined and is the same as in the
programme chart (see “Programme chart”).
- Pre-wash 1 to 3
Pre-washing removes coarse soiling and foaming agents.
- Main wash 1 and 2
Depending on wash load cleaning generally occurs at temperatures
between 50°C and 85°C with the addition of appropriate cleaning
agent.
- Interim rinse 1 to 4
In the interim rinse stages the chemical agents from the previous
wash blocks are rinsed away and neutralised where necessary by
the addition of neutralising agents.
- Final rinse 1 to 2
To avoid deposits on the wash load demineralised (AD) water
should preferably be used if available for the final rinse.
- Drying
Adequate drying reduces residual moisture on the load.
To Next Page
Loading...
