Miele PG 8593 - Programme parameters; Free memory

Programme parameters
166
Free memory New programme name:
Programme header Change volume of water[l] Spray arm monitoring LFMMc max. value (option) Drain time On Water intake Water drainage Standard Off for basket Set[µS/cm] Set[µS/cm] Increased Off Number of repeats
0/1
Number of repeats
0/1
Wash block Pre-wash Cleaning Interim rinse Final rinse
Parameter 1 2 3 1 2 1 2 3 4 1 2 Water quality
Dosage
1
Dispensing system Concentration[%]
2
Dispensing system Concentration[%]
Wash block temperature Holding time[Min] Monitor LFMMc (conductivity) Drying unit Cooling down pause Temperature 1 Cooling down with fan Automatic door opening  No Drying time 1[Min] No No/Programme end Set[seconds] Temperature 2 Set[seconds]
Drying time 2 Set[Min] Time changeable?
Yes/No
 =Customisable parameters Min =Holding time in minutes CW HW CWxx DI
=cold water =hot water =CW proportion in mixed water as percentage (CW70 = 70% CW + 30% HW) =aqua destillata, fully demineralised water (DI), demineralised water
DOS1 DOS3 DOS4
=cleaning agent =neutralising agent =DOS module