Miele PG 8593 - Process-Related Faults and Messages

Problem solving guide
141
Problem Cause and remedy
Fault578 The peak load cut-out has lasted longer than 3hours.
 Have your electrical system and your energy
management system tested by a suitably qualified
person.
Process-related faults and messages
Problem Cause and remedy
Fit a new HEPA filter! The maximum permissible operating hours for the HEPA
filter have been reached.
 Replace the HEPA filter with a new one.
 Reset the operating hours counter for the HEPA filter.
Drying during programme de-
activated
Drying cannot be selected at the start of a programme
because drying is not available for the selected
programme.
 Start the programme without drying.
Or:
 Have the drying parameters for this programme adjusted
by the Miele Customer Service Department.
Wrong code entered The PIN code entered is not the same as the code saved.
 Enter the PIN code again.
 Report the loss of the PIN code to the Miele Customer
Service Department.
Test programme: test object
can now be removed
This is not a fault.
A test programme is running to check performance. At
certain points in the programme the sequence is
interrupted so that samples can be taken.
 Take a sample.
or
 Wait. The programme will continue automatically in
approx. 30 seconds.
or
 Continue the programme without delay by pressing the
Start/Stop button.
Programme cancelled This is not a fault.
A programme which was running was cancelled by the
user.
 The wash cabinet interior can be very hot.
When the door is opened, hot steam and chemical
agents can escape. Protective measures for personal
safety must be observed.