Miele PG 8593 - Special 93°C-10

Programme parameters
178
Special 93°C-10'
Programme header Change volume of water[l] Spray arm monitoring LFMMc max. value (option) Drain time On Water intake Water drainage Standard Off for basket Set[µS/cm] Set[µS/cm] Increased Off Number of repeats
0/1
Number of repeats
0/1
Wash block Pre-wash Cleaning Interim rinse Final rinse
Parameter 1 2 3 1 2 1 2 3 4 1 2 Water quality CW70 HW HW DI
Dosage
1
Dispensing system DOS1 DOS3 Concentration[%] 0.6 0.1
2
Dispensing system Concentration[%]
Wash block temperature 93°C 75°C Holding time[Min] 10 1 1 3 Monitor LFMMc (conductivity) On Drying unit Cooling down pause Temperature 1 100°C Cooling down with fan Automatic door opening  No Drying time 1[Min]
20
No No/Programme end
Set[seconds] 30 Temperature 2
95°C
Set[seconds] 120
Drying time 2 Set[Min] 50 Time changeable?
Yes/No
 =Customisable parameters Min =Holding time in minutes CW HW CWxx DI
=cold water =hot water =CW proportion in mixed water as percentage (CW70 = 70% CW + 30% HW) =aqua destillata, fully demineralised water (DI), demineralised water
DOS1 DOS3 DOS4
=cleaning agent =neutralising agent =DOS module