Opening and closing the door
30
Opening the door using the emergency release
The emergency release may only be used when it is no longer
possible to open the door normally, e.g. in the event of a power
cut.
If the emergency release is operated during a programme cycle,
hot water and cleaning agents can escape.
Risk of scalding, burning and chemical burns.
Push against the door so that less force is needed to operate the
emergency release.
Push the tool supplied in the accessory pack horizontally into the
gap between the door and the lid or worktop. The right hand edge
of the tool must align with the outer right hand edge of the display.
Press against the unlocking mechanism with the tool until you hear
the door unlock. The door can now be opened.
If the washer-disinfector is switched on, activation of the emergency
release will be recorded in the process documentation and the
following message will appear in the display:
The message remains in the display until the door is closed. It is not
recorded if the machine is switched off.
To Next Page
Loading...
