Programme settings
113
Set the
holding time
The holding time is the duration in which the wash block temperature
is kept constant.
...
Holding time
Holding time
)Min
(0 - 15
1 Min
The duration can be set in 1minute increments. The possible range is
shown in the bottom line.
If chemical agents are to be dispensed in this wash block, the holding
time will at least equal the DOS exposure time. It is not possible to
set a lower value.
Use the arrow buttons (higher) and (lower) to set the holding
time.
Press OK to save the setting.
To Next Page
Loading...
