Miele PG 8593 - Page 115

Programme settings
115
Setting the
temperature and
time
The drying phase consists of two blocks. The temperature and
duration (holding time) must be set for each block.
The first block (temperature 1 and drying time 1) is not assigned in all
programmes, but if necessary can be set up by the Miele Customer
Service Department.
Setting
temperature 1
...
Temperature 1
Temperature 1
75
(50 - 115
°C
°C)
The temperature is set in 5° increments. The possible range is shown
in the bottom line of the display.
 Use the arrow buttons (higher) and (lower) to set the
temperature.
 Press OK to save the setting.
Setting drying
time1
...
Drying time 1
Drying time 1
30
(0 - 120
Min
Min
)
The holding time is set in 1minute increments. The possible range is
shown in the bottom line of the display.
 Use the arrow buttons (higher) and (lower) to set the holding
time.
 Press OK to save the setting.
Setting
temperature 2
...
Temperature 2
Temperature 2
75
(50 - 115
°C
°C)
The temperature is set in 5° increments. The possible range is shown
in the bottom line of the display.
 Use the arrow buttons (higher) and (lower) to set the
temperature.
 Press OK to save the setting.