Installation
*INSTALLATION*
155
Securing to the
worktop
To improve stability the machine must be secured to the worktop
after it has been aligned.
Open the door.
Screw the machine to the continuous worktop through the holes in
the front trim on the left and right.
Please contact the Miele Customer Service Department to secure it
at the sides to adjacent cabinetry.
Venting the
circulation pump
The gaps between a built-in machine and adjacent cabinetry
must not be sealed, e.g. with silicone sealant, as this could
compromise ventilation of the circulation pump.
Protective foil/
Worktop
protector
The protective foil supplied protects the worktop from damage
caused by steam when the door is opened. It should be positioned
underneath the worktop above the machine door.
To Next Page
Loading...
