Miele PG 8593 - Page 175

175
Oil programme
Programme header Change volume of water[l] Spray arm monitoring LFMMc max. value (option) Drain time On Water intake Water drainage Standard Off for basket Set[µS/cm] Set[µS/cm] Increased Off Number of repeats
0/1
Number of repeats
0/1
Wash block Pre-wash Cleaning Interim rinse Final rinse
Parameter 1 2 3 1 2 1 2 3 4 1 2 Water quality HW HW HW HW HW DI DI
Dosage
1
Dispensing system DOS4 DOS4 DOS1 DOS3 Concentration[%] 0.5 0.4 0.3 0.1
2
Dispensing system DOS1 DOS1 Concentration[%] 0.3 0.4
Wash block temperature 45°C 65°C 85°C 75°C Holding time[Min] 1 2 3 2 1 1 1 Monitor LFMMc (conductivity) On Drying unit Cooling down pause Temperature 1 Cooling down with fan Automatic door opening  No Drying time 1[Min] No No/Programme end Set[seconds] 30 Temperature 2
110°C
Set[seconds] 120
Drying time 2 Set[Min] 30 Time changeable?
Yes/No
 =Customisable parameters Min =Holding time in minutes CW HW CWxx DI
=cold water =hot water =CW proportion in mixed water as percentage (CW70 = 70% CW + 30% HW) =aqua destillata, fully demineralised water (DI), demineralised water
DOS1 DOS3 DOS4
=cleaning agent =neutralising agent =DOS module