Miele PG 8593 - Page 93

Further settings
93
Configuring the
interface
 The interface must only be configured by specialists.
 Open the menu as follows:
 button
Further settings
Interface
Interface
Ethernet
RS232
- Ethernet
Configuration of an Ethernet interface
- RS232
Configuration of a serial RS-232 interface
 Select the type of interface and confirm your selection with OK.
Then the parameters for the interface must be configured.
Ethernet
- Module status
Connection status displayed (Active/Inactive).
- Address status
List of interface parameters, e.g. IP address, Subnet mask etc.
- DHCP
The Ethernet interface can either be implemented via a Dynamic
Host Configuration Protocol (DHCP) or by setting the following
parameters:
– IP address
– Subnet mask
– Standard gateway
– DNS server automatic
– DNS server 1
– DNS server 2
– Port type
– Port